All Frigidaire products, including microwaves, are designed, engineered and assembled in the USA. For over 85 years, the producer has been focused on creating of innovative, accessible and reliable products. Find below the Frigidaire gallery troubleshooting table for microwaves. Each user can refer to it in case of malfunction of these Frigidaire units.
| OCCURRENCE | POSSIBLE CAUSE/SOLUTION |
|---|---|
| Control pads for Sensor Cooking. One-Touch Cooking, and Defrost will not operate. | The oven door was opened and dosed without initiating a cooking cycle within three minutes. Touch CLEAR/OFF to resume normal pad operation. |
| Microwave oven light does not come on. Cooling fan does not work. Turntable does not rotate. | If one of those situation appear please check the electrical outlet, fuse and/or drcuit breaker. If they are functioning properly, contact your nearest Electrolux Authorized Servicer. A microwave oven should never be servicer by a ‘do-it-yourself" repair person. |
| Water In a cup in microwave does not warm. | If this situation appears please check the electrical outlet, fuse and/or drcuit breaker. If they are functioning properly, contact your nearest Electrolux Authorized Servicer. A microwave oven should never be servicer by a ‘do-it-yourself" repair person. |
| Wall Oven Control Beeps and Displays any F code error (example F11). | Electronic control has detected a fault condition. Press CLEAR/OFF to clear the display and stop the beeping. Reprogram the oven. If a fault reoccurs. record the fault number. Press CLEAR/OFF and call Electrolux or another qualified servicer. |
| -dr- is displayed. | The door was left open and controls set for self-cleaning cycle. Close the door and push CLEAR/OFF pad. |
| Installation. | Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if rack and cabinet cutout flooring are not level. |
| Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are square and level. Contact cabinet maker to correct problem. |
|
| Entire Wall oven does not operate. | When the oven is first plugged in. or when the power supply to the oven has been interrupted, the display will flash. The oven cannot be programmed until the clock is set. |
| Be sure electrical cord is securely connected into the electrical junction box. | |
| Cord/plug is not installed anchor connected. Cord is not supplied with oven. Contact Electrolux or another qualified servicer. |
|
| Service wiring not complete. Contact Electrolux or another qualified servicer. | |
| Power outage. Check house lights to be sure. Call your local electric company. | |
| Short in cord/plug. Replace cord/plug. | |
| Controls are not set properly. | |
| House fuse has blown or circuit breaker has tripped immediately following installation. House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely. |